Mini Wind Turbine | Vertical Axis wind Mill | DIY Project| How to make tutorial

Share it with your friends Like

Thanks! Share it with your friends!

Close

Make mini wind turbine at home

———————————–

Power Companies DO NOT Want You To Know This !!!

http://bit.ly/NewPhysicist

Participate in DIY Home Energy System Course

———————————–

This mini wind turbine is very easy to make ansd can be used to recharge your smartphone. Make this mini wind turbine for kids. Mini wind turbine design for school project.

Click like button then start making your own small wind tutbine http://goo.gl/Ul4S5f

How to make Wind turbine (Vertical Axis). Step by step Instructions to make working model of small wind turbine or Vertical axis wind turbine (VAWT)

Things needed to Make Vertical Axis Wind Turbine

4” PVC Pipe 30 cm in length

ACP Sheet 30cm in length

Dynamo 3-5 Volt

PVC or CPVC Fittings 3T’s and 4 Elbows

Pieces of PVC or CPVC Pipe

L-Clamp Steel 4

Plate washer 2” IN Dia- 2

GI Nut that suits Dynamo Pulley

Connecting Wires

3/4” Cycle Screws 30

Powerbank

Tools needed to Make Vertical Axis Wind Turbine

Angle Grinder

Drilling machine

6mm drill bit

Welding machine (optional)

Multimeter

Spanner set

Other necessary equipment

How to Make Vertical Axis Wind Turbine (VAWT)

Step 1

Take PVC Pipe having 4inch diameter and 30 cm length.

Axially divide it into 4 equal parts using an angle grinder

Carefully use angle grinder

Make holes on one side of the PVC using 6mm drill bit

PVC 4” 30cm

PVC 4” 30cm

PVC Pieces

PVC Pieces

Sep 2

Cut 4 pieces of ACP Sheet having 30 cm in length and 6 cm in width

Mark holes on ACP from PVC Pieces and make holes Using 6mm drill bit.

ACP Pieces

ACP Pieces

Step 3

Buy 4 steel L-clamps and cut it into required length (12 cm * 6 cm) using an angle grinder.

Take care and wear glasses while using an angle grinder.

L clamp

L clamp

Step 4

Take GI Plate washer 2” in diameter

Take a GI nut that suits dynamo pulley

Weld GI Nut at the center of the plate washer

Then weld all 4 L-Clamps on the plate washer

Propeller frame is ready.

Plate Washer

Plate Washer

Plate washer and Nut

Plate washer and Nut

Welding

Welding

Propeller Frame

Propeller Frame

Step 5

Connect ACP Sheets and PVC pieces together using cycle screws.

Use a spanner to tighten it.

Then connect these propeller blades on propeller frame.

Wind turbine propeller is ready.

Propeller Frame

Propeller Frame

propeller propeller2

Step 6

Buy PVC or CPVC fittings (4 elbows, 3 T’s).

Join these components together to make wind turbine base.

Connect the wire to the dynamo and fix it on wind turbine base.

CPVC Fittings

CPVC Fittings

Wind Turbine Base

Wind Turbine Base

Dynamo

Dynamo

Step 7

Place propeller on the wind turbine base.

Vertical axis wind turbine is ready.

Place the wind turbine in front of a Fan.

Yeah. It’s working fine

Check the output voltage using a multimeter.

Comments

Write a comment